Unisteer 8010920-01 Late 1967-70 Mustang Rack Kit - Manual (Page 5)

Page 5 655650
7. Your rack has been shipped with the pressure and return line ports connected to it. You will
need to install the pressure and return line to the ports and install the rack with them
connected. The lower larger port on the rack is the pressure port and the higher smaller port
is the return. As you are going up into place with the bracket you will need to position the
lines around the motor mounts and header. This may take some time to find the angle you
need but position the lines where you need so that clearance is provided. Your rack and
pinion is also centered before shipping and is marked make sure not to move it off center or
loosen the mounting blocks on the gear itself.
8. Once the rack is in place leave the bolts loose and install the shaft and joint from the rack and
pinion to the steering column. Slide the shaft onto the u-joint on the column and snug the
pinch bolt. Run the shaft down to the pinion, with the pinion joint on the shaft, raise the rack
into place to spline the lower joint to the pinion. NOTE: It is important that you phase the u-
joint 90 degrees out or opposite of each other before you install and tighten. Also make sure
that you center your steering wheel before sliding the u-joints together. Torque the u-joint
bolts to 40ft. lbs.
Note: MAKE SURE YOUR RACK AND PINION IS CENTERED AND YOUR STEERING WHEEL
IS RESONABLY STRAIGHT.