Unisteer 8010920-01 Late 1967-70 Mustang Rack Kit - Manual (Page 4)

Page 4 655650
5. Once you have this done install the appropriate floor plate provided in your kit using the
hardware provided. Slide the floor plate over the column tube with the clamp and install the
column through the firewall and bolt back in place. Attach the new floor plate with supplied
hardware and complete the installation.
6. From under the car remove the stock round cross member from the frame rail to frame rail.
Install the new power rack and bracket in place using the stock holes where the cross
member was and install new hardware provided. Note: Always check to make sure that your
bracket is clear of the control arms and the lip of the frame around the camber adjusting
bolts. If the bracket rubs or hits anywhere it is necessary to grind a little of the edge of the
rolled lips of the metal on these parts. DO NOT GRIND ON THE SUPPLIED BRACKET.