Waldmann PULSE HFMD version VFC IV - with MFT, Typ I - Manual (Page 18)

18
Operating Manual Light Control „PULSE HFMD - Vers. IV“ ENG
Explanation of the functions (part 1)
Function 1.2
External switching
Function to operate the light via
external switching elements.
The default setting of the function
is „OFF”. When power is supplied
from an external place, the light
remains switched off.
If the function is active, the light
switches to the level which was set
last as soon as the power supply
is switched on (e.g. via a switched
power outlet).
The function can be changed on
switchable lights XXX /2
dimmable lights XXX /D
lights with sensors XXX /P
Function 1.1
Background light
Function to switch the logo back-
grond light on and off.
The function is basically set to
“ON”. The background lighting of
the logo is always active as soon
as the light is connected to the
power supply.
When you change the function,
the logo lights only with the light
switched on.
The function can be changed on
switchable lights XXX /2
dimmable lights XXX /D
lights with sensors XXX /P
For lights without the column op-
erating panel MFT, the function is
not available.
Fig. 3
Key I
Logo
Light
bar
Key II
LED I
LED II
Note: The functions written in
blue are not available.
Function 1.3
Burn-in function
Function for burning in the lamps
By default, the function is set ex
works to "OFF". When the burn-in
function is activated, the following
functions are disabled:
- Light control
- Presence function
- Dimming function
After 100 operating hours, the
function is automatically set to
"OFF" again, i.e., the light can now
be operated without restrictions.
The function can be changed on
lights with sensors XXX /P