Waldmann PULSE HFMD version VFC IV - with MFT, Typ I - Manual (Page 22)

22
Operating Manual Light Control „PULSE HFMD - Vers. IV“ ENG
Explanation of the functions (part 5)
Function 2.4
Sensor LED
Function to switch both LEDs in
the sensor operating panel on and
off (see fig. 4).
The function is normally switched
“OFF”, that is, the LEDs in the light
head are switched off.
For lights without the column
operating panel, the function is
switched to “ON”.
If the function is switched on, the
LEDs in the light head light in addi-
tion to the light bar display.
The function can be changed on
lights with sensors XXX /P
Function 2.5
Continuous operation
Setting function for continuous
operation.
The default setting of the function
is “OFF”.
The light operates continuously if
the function is switched on. Even
if no presence is detected, the light
lights at the lowest level.
The function can be changed on
lights with sensors XXX /P
Fig. 3
Fig. 4
Key I
Logo
Light
bar
Key II
LED I
LED II
Key I
+ LED I
Sensor Key II
+ LED II
Function 2.6
Parameter setting protection
Function for activating the param-
eter setting protection (required for
final inspection)
By default, the function is set to
"OFF".
When the function is switched on,
a factory reset will not overwrite
the set parameters. The parameter
setting of the electronic ballast
units will be carried out.
The function can be changed on
lights with sensors XXX /P