WarmlyYours Elements WarmlyYours Towel Warmers - Manual (Page 4)

Affi xing the Towel Warmer to the Wall
NOTE: Install the Towel Warmer no less than 1 foot from the fl oor and
near an electrical outlet. The electrical outlet must be properly grounded.
Position the brackets on the Towel Warmer to ensure that the Towel
Warmer is fi rmly affi xed to the wall. See pages 8,9 and 10 for for bracket
assembly and installation recommendations.
Step 1
Draw a diagram of the recommended location of the brackets on
the Towel Warmer box to create a template (see Step 2 for template
instructions). Two brackets must be mounted directly to a stud (see
pages 5, 6 and 7 for anchor points).
Step 2
Create the Template:
• Attach brackets into recommended position on the Towel Warmer
(see pages 8, 9 and 10 for recommended bracket assembly for each
model).
• Place Towel Warmer on the box (or a large sheet of paper) and lay on
a fl at surface with brackets facing downwards.
• Mark the location of the brackets on the template.
Step 3
Use the template as a guide to mark the wall with the correct locations
of the brackets. Make sure two of the brackets are lined up with a wall
stud. Ensure that all anchor points are clear of existing electrical or
mechanical systems.
Step 4
Using the template, check to make sure that the Towel Warmer will be
level once installed.
Step 5
Drill holes as required at the marked locations and install the brackets
into the wall using the hardware that has been provided. Use the drywall
anchors that are supplied for any bracket which is not being installed
into a stud.
3