Billion Electric Company BiGuard 50G - Manual (Page 101)

101
specific WAN port. In this menu are the following sections: General Settings,
Outbound Load Balance, Inbound Load Balance, and Protocol Binding.
4.4.3.1 General Settings
Mode: You can select Load Balance or Fail Over.
Service Detection: Enables or disables the service detection feature. For fail over,
the service detection function is enabled. For load balance, user is able to enable or
disable it.
Connectivity Decision: Establishes the number of times probing the connection
has to fail before the connection is judged as failed.
Probe Cycle: The number of seconds between each probe.
Probe WAN1: Determines if WAN1 is a gateway or host. If host is selected, please
enter the IP address.
Probe WAN2: Determines if WAN2 is a gateway or host. If host is selected, please
enter the IP address.
Fail back to WAN1 when possible: Enables or disables fail back to WAN1. This
function only applies to fail over.
Click Apply to save your changes.