Billion Electric Company BiGuard 50G - Manual (Page 99)

99
MAC Address: If your ISP requires you to input a WAN Ethernet MAC, check the
checkbox and enter your MAC address in the blanks below.
Candidates: You can also select the MAC address from the list in the Candidates.
DNS: If your ISP requires you to manually setup DNS settings, check the checkbox
and enter your primary and secondary DNS.
RIP: To activate RIP, select Send, Receive, or Both from the drop down menu. To
disable RIP, select Disable from the drop down menu.
MTU: Enter the Maximum Transmission Unit (MTU) for your network.
Network Address Translation: Enables or Disables the NAT function. To apply
this interface as router mode please select Disable. Due to default firewall feature,
if you would like to use router mode, you have to input the packet filter rules you
would like to forward in Configuration -> Firewall -> Packet filter
Click Apply to save your changes. To reset to defaults, click Reset.
A simpler alternative is to select Quick Start from the main menu. Please see the
Quick Start section of this chapter for more information.
4.4.2.2 Bandwidth Settings
Under Bandwidth Settings, you can easily configure both inbound and outbound
bandwidth for each WAN port.
WAN1: Enter your ISP inbound and outbound bandwidth for WAN1.
WAN2: Enter your ISP inbound and outbound bandwidth for WAN2.
NOTE: These values entered here are referenced by both QoS and Load Balancing
functions.