Billion Electric Company BiGuard 50G - Manual (Page 84)

84
IP Address: Enter the internal LAN IP address for BiGuard 50G (192.168.1.254 by
default).
Subnet Mask: Enter the subnet mask (255.255.255.0 by default).
RIP: RIP v2 Broadcast and RIP v2 Multicast. Check to enable RIP.
Wireless
WLAN Service: Default setting is set to Disable. If you have any wireless, both
802.11g and 802.11b, device in your network, you can select Enable.
Mode: The default setting is 802.11b+g (Mixed mode). If you do not know or have
both 11g and 11b devices in your network, then keep the default in mixed mode.
From the drop-down manual, you can select 802.11g if you have only 11g card. If
you have only 11b card, then select 802.11b.
ESSID: The ESSID is the unique name of a wireless access point (AP) to be
distinguished from another. For security propose, change to a unique ID name to the
AP which is already built-in to the router’s wireless interface. It is case sensitive and
must not excess 32 characters. Make sure your wireless clients have exactly the
ESSID as the device, in order to get connected to your network.
Note: ESSID is case sensitive and must not excess 32 characters.