BIXOLON IMPACT PRINTER SRP-270 - Manual (Page 12)

Rev. 3.02 - 12 -
SRP-270
2-2-3 Setting the DIP switch (IEEE1284 Parallel, USB Interface)
• DIP Switch 1
SW FUNCTION ON OFF DEFAULT
1 OFF
2
Emulation Selection Refer to the following Table 1
OFF
3 Auto-Cutter Enable Disable OFF
4 FONT SPACE 2 3 OFF
5 -
6 -
7
Function for Service Engineer
OFF
8 Korean Type Selection Unified Complete OFF
• DIP Switch 2
SW FUNCTION ON OFF DEFAULT
1
Auto Line Feed
Always
Enabled
Always
Disabled
OFF
2 Hex Dump YES NO OFF
3 Reserved - - OFF
4 Reserved - - OFF
5 Reserved - - OFF
6 Reserved - - OFF
7 Reserved - - OFF
8 Reserved - - OFF
• Table 1 – Emulation Selection
SW – 1 SW – 2 MODE
OFF OFF Epson
OFF ON Citizen
ON OFF Star
• Table 2 – Baud rate (bps) Selection
Transmission speed SW – 7 SW – 8
19200 baud ON ON
2400 baud OFF ON
4800 baud ON OFF
9600 baud OFF OFF