Rockwell Automation 1336S, 1336F, 1336E, 1336T, 1336-SN-SP18A Snubber Board Kit - Manual (Page 11)

1336-5.39 – August, 1999
I-11
Torque Specifications The following table lists fastener locations by component,
application, and torque specifications. Refer to “Torque Sequence” on
page I-4 for fastening two-point, four-point, and six-point
components to the heat sink.
SCR Module Access
Important: Before you remove connections and wires from the drive
components, mark the connections and wires to correspond with their
component connections and terminals to prevent incorrect wiring
during assembly.
Component Fastener Application Fastener Used
Torque
in.-lb
Torque
N-m
SCR Module Module to Heat Sink M6 x 16 mm Screw 52 5.9
Snubber Board Board to SCR M4 x 8 mm Screw 12 – 16 1.4 – 1.8
Gate Driver Board Mounting Plate Plate to Chassis M5 x 10 mm Screw 23 – 36 2.6 – 4.1
Control Board Mounting Plate Plate to Gate Driver Board Mounting Plate M6 Nut 23 – 36 2.6 – 4.1
Control Board Mounting Plate Plate to Gate Driver Board Mounting Plate M4 x 8 mm Screw 12 – 16 1.4 – 1.8
Enclosure Bottom, Top, and Side Panels Enclosure Sheet Metal M5 x 10 mm Screw 23 – 36 2.6 – 4.1
TB1 Wires Wires to TB1 M8 Nut 52 5.9
Converter Bus Bar Wires Wires to Converter Bus Bar M6 x 12 mm Screw 50 – 72 5.6 – 8.1
Ground Wire TE (Gate Driver Board) Wire to TB1 Terminal TE Compression 6 – 8 0.7 – 0.9
TB20 Wires, PLC Comm Adapter Board Wires to TB20 Captive Screw – –
TB21 Wires, PLC Comm Adapter Board Wires to TB21 on Main Control Board Captive Screw – –
TB5 Wires, Standard Adapter Board Wires to TB5 on Main Control Board Captive Screw 12 – 16 1.4 – 1.8
TB6 Wires, Standard Adapter Board Wires to TB6 on Main Control Board Captive Screw 12 – 16 1.4 – 1.8
TB7 Wires, Standard Adapter Board Wires to TB7 on Main Control Board Captive Screw 12 – 16 1.4 – 1.8
TB3 Wires, Standard Adapter or
L-Option Board Wires to TB3 on Control Interface Board or
L-Option Board
Captive Screw 8 – 10 0.9 – 1.1
Enclosure Door Ground Wire Wire to Enclosure Door M6 Nut 23 – 36 2.6 – 4.1
!
ATTENTION: Disconnect and lock out power from
the drive before disassembling the drive. Failure to
disconnect power may result in death or serious injury.
Verify bus voltage by measuring the voltage between
+DC and -DC on Terminal Block TB1. Do not attempt
to service the drive until the bus voltage has discharged
to zero volts.
ATTENTION: Wear a wrist-type grounding strap
when servicing drives. Failure to protect drive
components against ESD may damage drive
components. Refer to “Electrostatic Discharge
Precautions” on page I-4.