Rockwell Automation 1336S, 1336F, 1336E, 1336T, 1336-SN-SP18A Snubber Board Kit User Manual
Page 49
Advertising
1336-5.39 – August, 1999
I-49
1. Disconnect the following from the Main Control Board:
–
J2 ribbon cable connector
–
Comm connector
–
J10 ground wire at the stake on connector
–
J5 connector
–
All wires from the terminals on TB2 and TE
2. Slide the LEM harness out of the clip located at the top-left of the
Main Control Board Mounting Plate.
3. Remove the two screws fastening the bottom of the Main Control
Board Mounting Plate to the standoffs.
4. Remove the nuts fastening the top of the Main Control Board
Mounting Plate to the Gate Driver Board Mounting Plate.
5. Lift the Main Control Board Mounting Plate out of the drive.
6. Continue with “Gate Driver Board and Precharge Board
Advertising