Rockwell Automation 1336S, 1336F, 1336E, 1336T, 1336-SN-SP18A Snubber Board Kit - Manual (Page 37)

1336-5.39 – August, 1999
I-37
1. Remove the wires and connectors from the Standard or PLC
Comm Adapter Board.
2. Remove the wires and connectors from the Main Control Board.
3. Slide the LEM harness out of the clip located at the top-left of the
Control Board/Adapter Mounting Plate.
4. Remove the two screws fastening the bottom of the Control
Board/Adapter Mounting Plate to the standoffs.
5. Remove the nuts fastening the top of the Control Board/Adapter
Mounting Plate to the Gate Driver Board Mounting Plate.
6. Lift the Control Board/Adapter Mounting Plate out of the drive.
7. Continue with “Gate Driver Board and Precharge Board
Mounting Plates” on page I-50.