Rockwell Automation 1441-DYN25-Z Dynamix 2500 Data Collector - Manual (Page 43)

Rockwell Automation Publication 1441-UM001B-EN-P - September 2012 43
Configuring the Dynamic 2500 Data Collector Chapter 2
Follow these steps to replace the battery.
1. Using a flat head screwdriver, remove the two latch screws on the battery
access panel.
2. Remove the battery access panel.
3. Press the Reset button using a 1/16th inch diameter pin or a straightened
paper clip.
4. Replace the battery access panel and tighten the two screws.
The Dynamix 2500 data collector automatically powers on.
Allow at least thirty seconds for the instrument to reconfigure and activate the
display after the Instrument Setup screen appears.
The Data Collector’s Engineer Mode
The Engineer Mode Menu lets you to perform various maintenance operations
such as resetting the instrument to the default settings, or upgrading the
Dynamix 2500 data collector’s firmware.
IMPORTANT A hardware reset can also initiate the Engineer Mode Menu.
See The Data Collector’s Engineer Mode on page 43 for more
information.
IMPORTANT The current date, time and some status information will be lost, and
the backlight setting will be returned to the default setting following a
hardware reset.
See Set the Date, Time and Date Format on page 50 for more
information.
IMPORTANT Any data held in internal memory is secure and will not be lost nor
destroyed during a hardware reset.
ATTENTION: The Engineer Mode Menu can only be initiated
manually. This menu should be used only by an experienced person
who is familiar with these options.
ATTENTION: If you are not experienced and attempt to run options 2,
3, and 4, expect unwanted behavior and hardware damage.