Rockwell Automation 1336-SN-SP20A Snubber Board Kit - Manual (Page 22)

1336-5.40 – August, 1999
I-22
8. Remove the nut from the stud on the other side of the Heat Sink
Assembly bus bar and connect the white Snubber Board wire to
the stud. Refer to Figure I-11. Refer to “Torque Specifications”
on page I-11 for final tightening.
Replace the heat sink guard. Assemble the drive in reverse order of
removal. Refer to “Torque Sequence” on page I-4. Refer to “Torque
Specifications” on page I-11 for final tightening.
!
ATTENTION: Replace all guards before applying
power to the drive. Failure to replace guards may result
in death or serious injury.