Rockwell Automation 1395 Digital Reference Adapter for RTP Applications - Manual (Page 44)

Publication 1395-RTP-5.2 - September 1997
8-2 Parameter Table
Parameter – Memory location used to store Drive data. Each
parameter is given a number called the parameter number. The
parameter value may be specified in decimal, or in hexadecimal.
When specified in hexadecimal, the word “Hex” will appear after the
parameter value.
Source Parameter – Fast parameter used as a source of data.
Sink Parameter – Fast parameter used to receive data input.
Parameter Table NOTE: Since The Digital Reference Adapter Board is only mounted
in Port A, only the Port A parameters are listed in this chapter.
Table 1 provides an abbreviated listing of the Digital Reference
Adapter Board configuration parameters. The configuration
parameters in the Drive are categorized into the following groups by
parameter number:
• #400 – #409 = Port A Source Parameters
• #450 – #459 = Port A Sink Parameters
• #550 – #599 = Port A Set-up Parameters
The column headings in Table 1 are defined as follows:
Dec – Parameter number in decimal.
Hex – Parameter number in hexadecimal.
Name – Parameter name as it appears on the Programming Terminal.
Units – Indicates the units displayed for the parameter value using the
Programming Terminal and displaying the parameter value using
engineering units.
Init – Parameter value as it will appear after the Drive Initialize
command has been sent from the Programming Terminal or the
external device connected to Port A or B. The Init values are the same
as the Default values listed in the Parameter Descriptions section of
this chapter.
Min – Minimum allowable value for the parameter. If no min value is
given, the parameter has not been assigned a minimum limit.
Max – Maximum allowable value for the parameter. If no max value
is given, the parameter has not been assigned a maximum limit.
EE – Indicates whether the parameter can be backed up in EEPROM.
Function – Indicates the control function to which the parameter is
associated.
Port – Indicates port that the parameter is associated with.