Rockwell Automation 1492-PRINT220 ClearMark Quick Start - Manual (Page 10)

10
12. Load the 1492-M5X5 card.
13. Click “Print”. (Pop-up window appears: leave heat off and click [OK].)
14. If the "X" is centered, proceed to step 19.
15. If the "X" is not centered. Go to File -> Print, and Click [Calibration].
16. See Figure 13 for horizontal adjustments.
17. See Figure 14 for vertical adjustments.
Note: When making adjustments use maximum increments of 0.5 mm.
18. After making a change, Click [Save]. Then click [Print] to check the
card.
a. If centered go to step 19, If not go back to step 15.
Figure 13 -
Figure 14 -
If “X” appears
on this half of
the card
increase the
“Left” number
to move it back
to center.
If “X” appears
on this half of
the card
decrease the
“Left” number
to move it back
to center.
If “X” appears on this half of
the card
increase the “Top” number
to move it back to center.
If “X” appears on this half of
the card
decrease the “Top” number
to move it back to center.