Rockwell Automation 1494U-D30_D60_D100 Universal Disconnect Switch Installation Instructions (30A, 60A, 100A) - Manual (Page 6)

PN-224754
DIR 10001182729 (Version 01)
Verify that the cable assembly does not interfere with any mechanical and moving parts. Keep the cable conduit a minimum of 1/2”
from all heat sources and current carrying terminals, fuses, transformers, etc.
NOTICE
6” Diameter Min
Do Not Pinch Cable
NOTE:
All bends must be
greater than 6” in
diameter.
1 Locate switch as to not pinch the cable or create
a bend less than 6” in diameter.
1 Tighten cable nuts onto switch
bracket. 2 Use washer and hitch pin to attach cable
pivot to switch mechanism cable slot.
Check for one
washer on each
side of the switch
bracket.
Install pin as
shown. Do
not push past
second bend
on clip.
3 Remove drive bar for rod operation, washer
and hitch pin; discard.
Cable to Switch Mechanism Installation 2
When locating the 30A, 60A and 100A switch, verify that the minimum diameter for the loop of the cable between the switch
mechanism and the handle mechanism is not less than 6 inches.
IMPORTANT
30 - 35 lb-in
(6)