Rockwell Automation 1503 OEM Starter Frame Components Installation Manual - Manual (Page 6)

1-2 OEM Starter Frame Installation
1503-IN050E-EN-P – June 2013
Installation (Cont.) Standards and Codes (Cont.)
The OEM starter frame assembly was fully tested and inspected at the
factory. Unless damage from shipping is suspected, the commissioning pro-
cedures in Chapter 4 of this manual should be the only additional checks
required for the unit.
Imperial Tool Requirements
I M P O R T A N T I M P O R T A N T Some components of this product incorporate Imperial
hardware. Rockwell Automation recommends the use of the appropriate
tools to successfully complete the assembly and maintenance procedures
for these components. If you cannot obtain such tools, contact your area
Rockwell Automation sales offi ce for assistance.
The following Imperial size tools are recommended for installation and
maintenance of the OEM starter frame and components:
• Standard drive ratchet with extension
• Standard drive torque wrench
• Standard drive sockets: 9/32, 3/8, 7/16, 1/2, 9/16, 3/4 in.
• Open-end wrenches: 7/16, 1/2, 9/16, 11/16, 3/4, 7/8 in.
• Drill and drill bits: 0.172, 0.219, 0.281 in.
• Slot-head screwdrivers
• Feeler gauge set (0.125 in to 0.300 in.)
• Locking pliers
• High potential tester
Metric Tool Requirements
I M P O R T A N T I M P O R T A N T
Metric equivalent sizes are provided in parentheses
where applicable. It is important to note that all sizes given are not exact
substitutes for the corresponding Imperial sizes. To ensure proper installa-
tion, use the recommended metric hardware and dimensions for pilot holes
and clearance holes.
The following metric size tools are recommended for installing the OEM
frame and components with metric hardware.
• Standard drive ratchet with extension
• Standard drive torque wrench
• Standard drive sockets: 8, 10, 13, 15, 18 mm
• Open-end wrenches: 8, 10, 13, 15, 18 mm
• Drill and drill bits: 4.6, 5.5, 6.8 mm
• Slot-head screwdrivers
• Locking pliers
• Feeler gauge set (3mm to 8 mm)
• High potential tester