Maintenance – Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Installation Instructions, PRIOR to Firmware rev. 3.0 User Manual
Page 51
Publication 1404-IN007D-EN-P - October 2004
Powermonitor 3000 51
Maintenance
Accessing Self-test/Diagnostic Data using Display Module
You can access valuable diagnostic information using the optional
Display Module. Connect the Display Module to the Master Module
using the Display Module cable. Using the four control keys, navigate
through the menus to “Display” - “Status” and select using the Enter
key. The Display Module then displays the following data. Use the up
and down arrow keys to step through the status data.
•
- the unit catalog number and series revision letter.
•
- displays the revenue meter accuracy class.
•
- the unit’s unique Warranty Identification Number
(needed for service and optional firmware enhancements).
•
- displays details of the digital board, analog board,
and ASIC revisions.
•
- shows the Master Module
firmware revision.
•
- shows the units device ID number
assigned at the factory. This number is also used in the default
address for native RS-485, and optional RS-232 and Ethernet
communications.
•
- displays a status code bitfield
as a hex number. A non-zero value indicates a problem.
•
- indicates the health of the flash memory
code area.
•
- indicates the health of the random-access memory.
•
- indicates the health of the flash memory
data area.
•
- indicates the health of the super-cap backed
non-volatile random access memory.
•
- indicates the data acquisition system health.
•
- indicates the system watchdog timer status.
•
- indicates the health of the real-time clock.
•
- displays the firmware revision of the optional
communications card (if applicable).
•
- displays the optional communication card type.
ATTENTION
Use a 1786-CP cable when connecting a
programming terminal to the network through NAPs.
Using a commercially available RJ-style cable could
result in network failure.