Mount the ups – Rockwell Automation 1609 Industrial Uninterruptible Power Supply - Series D User Manual
Page 4
5. Insert the batteries into the battery compartment in the orientation as shown in the photo below.
6. Open the white connector retainer and connect the two cables together as shown in the photo below.
7. To complete the battery installation, insert the surplus wire harness into the free space, close the white
connector retainer and reattach the battery door with the six screws (torque of 8.7+/-1.7 lb-in).
Mount the UPS
The UPS-D is designed to mount on the back of the panel or to the floor of the enclosure. The UPS
mounts to a bracket assembly (1609-BRK) that allows it to mount to either the panel or floor (see
Diagram 1 below).
Diagram 1
Bulletin 1609 Industrial Uninterruptible Power Supply
4
Publication 1609-IN012B-EN-P - August 2012 DIR 10000234085 (Version 01)
Cut-Out Hole
Connector
Retainer