Rockwell Automation 1732D-XXXX PointBlock 16 dc Input Module Installation Instructions - Manual (Page 6)

6 DeviceNet 1732 ArmorBlock 16-Point I/O, Series A
Publication 1732D-IN002B-EN-E - January 2013
To reset the node address:
1. Rotate the switches using a small blade screwdriver.
2. Line up the small black dot on the switch with the number setting you wish to
use.
3. Cycle power.
Set Node Address
The rotary switches are read periodically. If the switches have been changed since the last
time they were read and they no longer match the online address, a minor fault occurs,
which is indicated by a flashing red Module Indicator.
Settings of 64 through 99 cause the module to use the last valid node address stored
internally. For example, the last setting internally was 40. If a change is made to 68, and
then you power up, the address defaults to 40.
The module is equipped with AutoBaud detect. AutoBaud lets the module read the
settings already in use on your DeviceNet network and automatically adjusts to those
settings.
Mount the Module
Two sets of mounting holes are used to mount the module directly to a panel or machine.
Mounting holes accommodate #6 (M3) pan head screws. The torque specification is 0.64
Nm (6 in-lb).
Product Dimensions
Refer to the mounting dimensions illustration to help you mount the module.
Example shows
default node
address set at 63.
43968