Rockwell Automation 1746-MPM INSTALL INSTRUC MOLD PRESSURE - Manual

Publication 1746-5.13 July 1998
Installation Instructions
Mold Pressure Module
(catalog number 1746-MPM)
Before you begin
Use this document as a guide to installing and powering-up your Mold
Pressure Module. We assume that you are already familiar with the SLC
500 ™ family of Small Logic Controllers and associated I/O modules.
Tools that you need
• 1/4” slotted (#2) or phillips screwdriver
• needle-nose pliers
Handling the module
Take these precautions to guard against ESD damage:
!
ATTENTION: Electrostatic discharge can damage the
module. Follow these guidelines:
• touch a grounded object to discharge potential static
• wear an approved grounding wriststrap
• do not touch circuit components inside the module
• if available, use a static-safe work station
• when not in use, store the module in its anti-static bag.
!
ATTENTION: Do not insert or remove this module while
backplane power is on. An electrical arc may occur that can
cause an explosion in a hazardous environment and/or cause
damage to the module or degrade its performance.