Remove a mounting base – Rockwell Automation 1734-8CFG POINT I/O Module with 8 Configurable 24V DC Points IN User Manual
Page 11
Advertising
POINT I/O Module with 8 Configurable 24V DC Points 11
Publication
1734-IN038A-EN-P - October 2008
Remove a Mounting Base
To remove a mounting base, you must first remove any installed module and
the module installed in the base to the right.
1. For a module with a two-piece terminal base, use these steps;
otherwise, use
a. Remove the removable terminal block (RTB), if wired.
b. Unlatch the RTB handle on the I/O module.
c. Pull on the RTB handle to remove the RTB.
2. Press on the module lock on the top of the module.
3. Pull on the I/O module to remove from the base.
4. Repeat steps 1, 2, 3, and 4 for the module to the right.
5. Lift straight up to remove.
Advertising