Auxiliary power cable, M18-style 4-pin male auxiliary power connector – Rockwell Automation 1732D-8X81212HD DNet ArmorBlock Network and Auxiliary Powered Module, Series A, IN User Manual
Page 10
10 DeviceNet ArmorBlock Network and Auxiliary Powered Module, Series A
Publication
1732D-IN011A-EN-E - April 2009
Auxiliary Power Cable
Refer to the pinout diagram to attach auxiliary power.
M18-style 4-pin Male Auxiliary Power Connector
Refer to publication
for Rockwell Automation cable and cord
set offerings or access the Connection Systems website at
.
ATTENTION
If any I/O devices connected to this equipment require Class 2 power to
operate, this equipment and all connected I/O must be powered by a Class 2
source.
To comply with the CE Low Voltage Directive (LVD), this equipment and all
connected I/O must be powered from a source compliant with the following:
Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV).
ATTENTION
Make sure all connectors and caps are securely tightened to properly seal the
connections against leaks and maintain IP enclosure type requirements.
4
2
1
3
43906
(View into Connector)
Pin 1
Output Power+
Pin 2
No Connection
Pin 3
No Connection
Pin 4
Output Power-