Rockwell Automation 1738-AENT ArmorPoint EtherNet/IP Adapter, Series A - Manual (Page 6)

Publication 1738-IN017B-EN-E - March 2005
6 ArmorPoint EtherNet/IP Adapter, Series A
Mount the Adapter and
I/O Base
To mount the ArmorPoint adapter on a wall or panel, use the screw
holes provided in the ArmorPoint adapter.
A mounting illustration for the ArmorPoint adapter with I/O bases is
shown below.
Install the mounting base as follows:
1. Lay out the required points as shown above in the drilling
dimension drawing.
2. Drill the necessary holes for #8 (M4) machine or self-tapping
screws.
3. Mount the adapter using #8 (M4) screws.
4. Ground the system using the ground lug connection in the I/O
base. (The ground lug connection is also a mounting hole.)
43769
4.02 in.
102 mm
1.81 in.
46 mm
Adapter
1.9 in.
47.2 mm
2.0 in.
50 mm
0.87 in.
22 mm
2.0 in.
50 mm
0.87 in.
22 mm
2.0 in.
50 mm