Rockwell Automation 1734-ADN, ADNX Point I/O DeviceNet Adapter Installation Instructions User Manual
Page 11
Advertising
POINT I/O DeviceNet Adapter 11
Publication
1734-IN026A-EN-P - April 2005
For information about how to remove POINT I/O modules
from the DIN rail, see the associated publications for those
modules.
4. Use a small-bladed screwdriver to rotate the DIN rail locking
screw to a vertical position and release the locking
mechanism.
5. Pull the adapter off of the DIN rail to remove it from the
existing system.
6. Insert the new adapter into slot 0 using the steps described in
the Install the Adapter section of this manual on page 6.
7. Reattach I/O modules to the new adapter.
RTB removal handle
42511
42417
Advertising