Install the adapter – Rockwell Automation 1734-ADN, ADNX Point I/O DeviceNet Adapter Installation Instructions User Manual
Page 6
6 POINT I/O DeviceNet Adapter
Publication
1734-IN026A-EN-P - April 2005
Install the Adapter
To install the adapter on the DIN rail prior to installing other base
units, proceed as follows.
1. Position the adapter vertically in front of the DIN rail.
2. Press firmly to install the adapter on the DIN rail.
The locking mechanism locks the adapter to the DIN rail.
ATTENTION
POINT I/O is grounded through the DIN rail to
chassis ground. Use zinc-plated, yellow-chromated
steel DIN rail to assure proper grounding. The use
of DIN rail materials (e.g., aluminum, plastic, etc.)
that can corrode, oxidize, or are poor conductors,
can result in improper or intermittent grounding.
Secure DIN rail to mounting surface approximately
every 200 mm.
1734-ADN(X)
communication
interface
31110-MC
DIN rail
Orange
screw slot