Rockwell Automation 1779-KP5_KP5R ORD.1779-5.3 - Manual (Page 25)

Installing the 1779ĆKP5 Module
Chapter 3
3Ć12
3. After you finish setting the resistor, push the removable frame back
to the operating position and tighten the four fasteners on the front of
the module. The fasteners must be tight to ensure that AC power is
not interrupted by the interlock switch on the power-supply board.
After you have set the switches and the terminator, you can connect the
communication cables necessary for your application.
The following sections provide information for connecting the 1779-KP5
to:
Data Highway II
Data Highway Plus
1784-T50 Industrial Terminal
CAUTION: The DHII AUX ACCESS connector on the front
panel of the module is for future product enhancement. To help
protect this connector from electrostatic discharge, make sure
that the conductive cap (shipped with the module) remains on
the connector.
Connecting the Data Highway II and Data Highway Plus
The 1779-KP5 has a connector for the Data Highway II network and a
connector for the Data Highway Plus network. You must connect a drop
cable from each network to the 1779-KP5 (Figure 3.5).
If you have a 1779-KP5R, you must connect a drop cable for each Data
Highway II cable system.
The drop cable for Data Highway II is provided with the Data Highway II
tap (Cat. No. 1779-XP). For more information on Data Highway II
cabling, refer to the Data Highway II Cable Planning and Installation
Manual (Publication 1779-6.5.7).
Connecting Communication
Cables