Rockwell Automation 1779-KP5_KP5R ORD.1779-5.3 - Manual (Page 51)

Addressing from Data Highway Plus
Chapter 5
5Ć9
words from Memory Location N100:0 of the remote PLC-5 and stores
them in Memory Location N100:0 in the initiating PLC-5.
MESSAGE INSTRUCTION DATA ENTRY FOR CONTROL BLOCK N13:0
Read/Write: READ
PLC-5 Data Table Address:
Press a key to change a parameter or <RETURN> to accept parameters.
[
Program No Forces No Edits PLC-5/15 ADDR 20
READ/
WRITE
F1
PLC-5
ADDRESS
F2
SIZE IN
ELEMENTS
F3
LOCAL/
REMOTE
F4
REMOTE
STATION
F5
LINK
ID
F6
Remote Station:
Link ID:
Remote Link Type:
Size in Elements:
Local/Remote:
Local Node Address:
Processor Type:
Destination Data Table Address:
N100:0
1000
REMOTE
Node = 055 User = 013
00
DATA HIGHWAY II
50
PLC-5
N100:0
REMOTE
LINK
F7
LOCAL
NODE
F8
PROC.
TYPE
F9
DESTIN
ADDR
F10
BLOCK SIZE = 11 WORDS
There are two ways to communicate to a remote Data Highway Plus link:
Using a Data Highway II Link Number
Using a Data Highway Plus Link Number
The following sections show these two methods.
Using a Data Highway II Link Number
This method limits you to addressing a total of 15 nodes (02 through
20 octal) on a Data Highway Plus link, but it is also easier to implement.
Important: The address of the initiating Data Highway Plus node must
be between 02 and 20 (octal) so that the reply message can be returned.
The address of the initiating Data Highway Plus node must be between 02
and 20 (octal) so that the reply message can be returned.
Figure 5.4 shows an example configuration using a remote Data Highway
Plus link.
Communicating to a Remote
Data Highway Plus