Rockwell Automation 1734-OA4, Series C POINT I/O 120/220V AC Output Module Installation Instructions - Manual (Page 11)

POINT I/O 120/220V AC Output Module 11
Publication 1734-IN009E-EN-E - March 2013
Install the Removable Terminal Block
A Removable Terminal Block (RTB) is supplied with your wiring base assembly. To
remove, pull up on the RTB handle. This allows the mounting base to be removed and
replaced as necessary without removing any of the wiring. To reinsert the Removable
Terminal Block, proceed as follows:
1. Insert the end opposite the handle into the base unit. This end has a curved
section that engages with the wiring base.
2. Rotate the terminal block into the wiring base until it locks itself in place.
3. If an I/O module is installed, snap the RTB handle into place on the module.
WARNING: When you connect or disconnect the Removable Terminal Block
(RTB) with field side power applied, an electrical arc can occur. This could cause
an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
22 0V AC Inp ut
Mo du le
St at us
Ne tw or k
Sta tu s
NO DE :
0
1
44011
Insert the module
straight down into
the mounting base
Hook the RTB end into
the mounting base end
and rotate until it locks
into place