Rockwell Automation 1783-US8T Stratix 2000 Ethernet Unmanaged Switch Installation Instructions - Manual (Page 8)

8 Stratix 2000 Ethernet Unmanaged Switch
Rockwell Automation Publication 1783-IN010A-EN-P - June 2013
Remove the Switch from a DIN Rail
1. Gently push the switch downward to compress the mounting clip spring.
2. Rotate the bottom of the switch away from the DIN rail until the bottom of the
mounting clip is clear of the lower rail.
3. Lift the switch up until the mounting clip and springs clear the upper DIN rail.
Wire the Switch
For simplified cabling, the switch supports automatic medium-dependent interface
crossover (auto-MDIX). With auto-MDIX, the switch detects the required cable type for
copper Ethernet connections and configures the interfaces accordingly. You can use either
crossover or straight-through cables for connections to the switch's 10/100 Ethernet ports,
regardless of the type of device on the other end of the connection.
Use either straight-through or crossover style, twisted four-pair, Category 5e or better
cables with RJ45 connectors to connect to the switch's Ethernet ports.