Rockwell Automation 6156 Industrial 14 inch CRT Monitors - Manual (Page 16)

Industrial 14” CRT Monitors 16
Publication 6156-2.0
5. For monitors configured with the touchscreen option, connect one
end of the serial touchscreen cable to the connector labeled
”AUX1” on the rear panel of the monitor. Tighten the captive
screws to secure it.
6. Route and secure the cables. In cases where the cable crosses a
door hinge, be sure to leave enough excess cable for a loose fit in
all door positions. Bulletin 6156 Industrial Monitor cables are
designed to be flexible, so routing across a hinge should not result
in application failure. The minimum recommended bend radius
for a video cable is 38 mm (1.5 in.).
7. Connect the standard 15-pin connector end of the video cable to
the computer’s video output connector. Tighten the captive
screws on the cable connector to secure it.
8. Connect the keyboard cable to the keyboard input connector on
the computer.
9. Connect the touchscreen cable free end to an appropriate RS-232
communications port on the computer. Tighten the captive screws
on the cable connector to secure it.
10. If you are installing an RS-232 serial communications cable,
connect the free end to an appropriate RS-232 port on the
computer.
11. Coil and secure any extra cable length in a convenient location.