Rockwell Automation AutoMax R-Net Processor Module - Manual (Page 8)

1Ć2
D JĆ3684 ReSource AutoMax PROGRAMMING EXECUTIVE
INSTRUCTION MANUAL VERSION 2.0
D JĆ3750 ReSource AutoMax PROGRAMMING EXECUTIVE
INSTRUCTION MANUAL VERSION 3.0
D J2Ć3009 RĆNet CABLE INSTALLATION MANUAL
D Other instruction manuals applicable to your hardware
configuration.
D Your personal computer and DOS instruction manuals
D IEEE 518 GUIDE FOR THE INSTALLATION OF ELECTRICAL
EQUIPMENT TO MINIMIZE ELECTRICAL NOISE
INPUTS TO CONTROLLERS.
1.2 Related Hardware and Software
M/N 57C429 contains the AutoMax RĆNet Processor Module. It is
used with the following hardware and software (purchased
separately):
1. M/N 57C395 ReSource AutoMax Programming Executive
software Version 3.0.
2. M/N 57C390 or 57C391 ReSource AutoMax Programming
Executive software Version 2.0.
3. M/N 57C304 or 57C305 ReSource AutoMax Programming
Executive software Version 1.0.
4. M/N 57C300 or 57C301 ReSource DCS 5000 Programming
Executive software.
5. M/N 57C430 AutoMax Processor.
6. M/N 57C407 DCS 5000 Processor.
7. M/N 61C126 or 61C128 ReSource Portable Computer, or other
IBMĆcompatible personal computer running DOS Version 3.1 or
later.
8. M/N 61C127 RSĆ232C ReSource Interface Cable. This cable is
used to connect the personal computer to the Processor module.
Item 7 above includes this cable, but it can also be purchased
separately.
9. M/N 45C70 Coax BNC Tee Connector. This is required at each
node for connection to coaxial cabling.
10. M/N 45C71 Coax BNC 75 Ohm Terminating Load. All coax
systems require a terminating load at both ends of the cable.