Mounting on the din rail – Rockwell Automation 1440-TB-A XM-940 Dynamic Measurement Terminal Base User Manual
Page 14
Advertising
14 XM-940 Dynamic Measurement Terminal Base
Publication
GMSI10-IN020C-EN-P - October 2013
Mounting on the DIN Rail
You can also mount the terminal base to a grounded mounting plate. Refer to
the XM-124 Standard Dynamic Measurement Module User Manual,
publication
1. Position the terminal base unit on the 35 x 7.5mm DIN rail (A)
(Allen-Bradley pt no. 199-DR1 or 199-DR4) at a slight angle.
2. Slide the terminal base unit over leaving room for the side
connector (B).
Position terminal base at a slight angle and hook over the top of the DIN rail.
Advertising