Rockwell Automation 1440-TB-A XM-940 Dynamic Measurement Terminal Base - Manual (Page 15)

XM-940 Dynamic Measurement Terminal Base 15
Publication GMSI10-IN020C-EN-P - October 2013
3. Hook the lip on the rear of the terminal base onto the top of the DIN
rail, and rotate the terminal base onto the rail.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a
screwdriver or similar device to open the locking tab, press down on
the terminal base until flush with the DIN rail and release the locking
tab to lock the base in place.
5. Connect the wiring for the XM-940 terminal base unit as shown in
Wiring on page 17 .