Bowe, Bell + Howell S006830 - Manual (Page 21)

www.bbhscanners.com
21 of 142
Power Source
Caution
• Power requirements: Power outlet with AC 100–120 V, 50/60 Hz or AC 220–240, V 50/60 Hz.
• Use a voltage level that does not vary more than ±10% from the voltage level marked on the
scanner nameplate. The nameplate is located on the back side of the scanner.
• The scanner must be connected to a grounded outlet.
• The scanner should be used only with the power cord that is supplied with the scanner or with a
power cord that has been approved by a certified electrical contractor.
• Do not use an extension cord.
Handling the CD-ROM
To prevent accidental damage to CD-ROMs, handle them carefully as shown below:
• Do not touch or write on the surface of the disc.
• Do not leave the disc out of the protective case.
• Do not leave the disc in direct sunlight or near heat sources.