Rockwell Automation 1440-SPD02-01RB XM-220 Dual Speed Module - Manual (Page 9)

Rockwell Automation Publication ENMON-IN220D-EN-P - February 2014 9
XM-220 Dual Speed Module
Reset Switch
The XM-220 module has an external reset switch on top of the module. The Reset switch can be used to reset all latched
relays, including the relays in the Relay Expansion module when it is attached to the XM-220 module.
Install the XM Serial Configuration Utility Software
The XM Documentation and Configuration Utility CD is packaged with the XM modules. It contains the XM Serial
Configuration Utility software, a set of user guides, hazardous location installation drawings, and electronic data sheet
(EDS) files that are used by network configuration tools such as RSNetWorx™ for DeviceNet software. The user guides are
in portable document format (PDF), and must be viewed with Adobe Acrobat Reader software.
To install the XM Serial Configuration Utility software, follow these steps.
1. Insert the XM Documentation and Configuration Utility CD-ROM into the CD-ROM drive.
2. Follow the instructions that appear to install the XM Serial Configuration Utility.
3. When you are finished installing the software, remove the XM Documentation and Configuration Utility
CD-ROM from the CD-ROM drives; store it in a safe place.
WARNING: When you press the reset button while power is on, an electrical arc can occur. This could cause an explosion in
hazardous location installations. Be sure that power is removed or the area is nonhazardous before proceeding.
IMPORTANT The Reset switch resets the relays only if the input is no longer in alarm or the condition that caused the alarm is no longer
present.
If autorun is Then
Enabled The Setup program starts automatically and the XM Serial Configuration Utility opening screen appears.
Disabled Follow these steps.
1. Click Start, and then click Run.
The Run dialog box appears.
2. In the Open box, type x:\autorun, where x is the letter of the drive containing the XM Documentation and
Configuration Utility CD-ROM.
3. Click OK.
The XM Serial Configuration Utility opening screen appears.
DUAL SPEED
1440-SPD02-01RB
Reset Switch