AJA V2Analog - Manual (Page 6)

V2Analog v1.0 www.aja.com 6
User Controls
The V2Analog converter has two user interfaces:
• DIP switch settings
• MiniConfig via USB
The DIP switch 1 setting determines which configuration parameters the converter will
use. When Off the unit is set to Local, and the DIP switch settings will be active. When On
the unit is set to Remote, and will use the MiniConfig settings. MiniConfig settings are
non-volatile and are retained through power cycles.
External DIP
Switches
The V2Analog has a 4-switch DIP accessible through a cut-out in the bottom of the unit.
For specific DIP switch setting information, see
“DIP Switch Settings” on page 8 .
MiniConfig Control
MiniConfig is an AJA software application used for configuring and updating the
firmware of several AJA Mini-Converter products. Configuration set via MiniConfig is
stored in the unit through subsequent power cycles. See
“USB Control and Setup—Using
AJA MiniConfig” on page 9 .
Installation
Typically, V2Analog installation consists of the following:
1. Disconnect +5VDC from the converter.
2. Configure the DIP switches for the desired equipment configuration and video
formats.
3. Connect video equipment to the converter BNCs
4. Apply power to the converter (AJA power supply included).
Alternatively, you can set the unit to Remote operation using DIP switch 1, connect the
unit to a PC or Mac via USB, and then use MiniConfig to configure the unit. The
MiniConfig application is available for download from the AJA website.
NOTE: Threaded holes (unified 4-40) located on the bottom of the unit can be used for mounting.
Specifications
Formats • 525i/625i, 1080i 50/59.94/60 Hz
• 1080p, psf 23.98/24/25/29.97/30 Hz
• 720p 50/59.94/60 Hz
Inputs • HD/SD-SDI, SMPTE-259/292, 1 x BNC
Outputs • HD component YPbPr, RGB (SMPTE-274/296), BNC
• SD component (Betacam, EBU-N10)/composite/YC (S-Video), 3 X BNC