Bally Refrigerated Boxes Mortuary Cooler Systems - Manual (Page 5)

REV: 6/2014 IM-418-11 © 2014 Bally Refrigerated Boxes, Inc. 5
Caulking Mortuary Cooler
A. Make final checks of Mortuary Cooler panels for
a square and plumb installation. Add or
remove shims as needed.
B. Caulk bottom of the exterior and interior of wall
panels using a silicone sealant that is mildew
and waterproof.
Installing Refrigeration Unit
A. Refrigeration unit is positioned as shown on plan view.
Use the listed weights of refrigeration units to determine
the method of lifting. The end of the refrigeration unit
that is opposite of the bottom vent is the heavier end
containing the compressor. Cardboard placed on top of
Mortuary Cooler will help slide refrigeration unit into
place and protect exterior finish.
Ensure that refrigeration unit is not stored or moved from horizontal.
Installing SaniTray Rack and Tray
A. The SaniTray cross members and side rails on the
1-3 body cooler are identical.
B. Position cross members within vertical channel
slots with the ball bearing side facing up and the
open side facing to the rear. Install clamps halves
and hardware and tighten when cross member is
level and at desired height. See Figure 9 and 10.
C. The guide channels are marked left and right and
top, middle (if there is a third tier) and bottom.
These must be positioned as marked. It will be
easier to adjust and secure guide channels if
bottom guide channels are mounted first and
then the next immediate levels.
D. Position bottom level guide channels with the
open ends facing inwards. Install mounting
hardware loosely and slide body tray fully into
Mortuary Cooler. Align body tray within guide
channel adjustment to slide straight out of
Mortuary Cooler. Tighten hardware for guide
channels. Guide channels should fit loosely
against body tray. Remove body tray out the way
before installing next row of guide channels.
Figure 9:
Clamp Detail for Body Tray Racks
Figure 10:
Assembly of Body Tray Rack