Bang & Olufsen BeoCenter AV5 - User Guide - Manual (Page 54)

> BeoCenter AV5 close-up operation
54
Direct access sockets
PHONES R L VIDEO S–VHS 1 INPUT 2
BeoCenter AV5 direct access socket panel –
Just below the close-up operation panel, you will
find a small socket panel conveniently placed for
connection of headphones, Camcorder, pointing
devices and keyboard.
PHONES (Headphones)
You can connect stereo headphones to the socket
marked PHONES. Cut out the BeoCenter AV5
loudspeakers by pressing the Beo4 volume button
right on the middle. Once you remove the
headphones, press the volume button again to
demute the BeoCenter AV5 loudspeakers.
L, R, VIDEO, S-VHS for Camcorder
The sockets marked, L, R, VIDEO, and S-VHS are
for Camcorder connections:
L, R sockets… For audio connection (Left and
Right respectively).
VIDEO socket… For the video signal.
S-VHS socket… For connection of a S-VHS
Camcorder or Hi-8 Camcorder only.
To watch your Camcorder recordings on the
BeoCenter AV5, connect the Camcorder and
switch the BeoCenter AV5 on by pressing, e.g. TV
on Beo4. Now switch on your Camcorder, the
signal is automatically registered in your
BeoCenter AV5 and the pictures appear on the
screen.
If you switch to e.g. TV by accident while you are
watching your Camcorder recordings, the signal
from the Camcorder will be switched off. To bring
the signal back, just switch off the Camcorder and
then switch it back on again. The pictures from
your Camcorder recordings should now appear on
the screen again.
INPUT 1 and 2
The sockets marked INPUT 1 and 2 are for
connection of various pointing devices.
When you connect a pointing device, you must
make sure that BeoCenter AV5 is switched to
standby before you connect or disconnect the
device.
If you wish to connect a CD-i keyboard to
BeoCenter AV5, you must connect it to the socket
marked INPUT 1.