Bang & Olufsen BeoSystem 1 - User Guide - Manual (Page 41)

41
Connect the IR receiver
To facilitate remote control operation of
BeoSystem 1 and all connected equipment,
you must connect the IR receiver to
BeoSystem 1.
The IR receiver is a kind of ‘eye’ which is
capable of receiving signals from your Beo4
remote control and sending them to
BeoSystem 1. BeoSystem 1 then sends the
appropriate control signals to your screen,
projector or other connected equipment.
To connect the IR receiver…
> Detach the IR receiver’s rear cover (unscrew the
two (C) screws and loosen the two (D) screws,
then lift off the cover).
> Cut the included cable to the required length
and strip the cable.
> Insert the cable end through the cable clamp (E)
and connect the leads to the terminals inside
the receiver in the order indicated. Tighten the
clamp.
> Attach the rear cover and fasten the IR receiver
to the wall as described below.
> Connect the cable to the IR RECEIVER socket on
BeoSystem 1.
To fasten the IR receiver to the wall…
> Using the wall bracket as a template, mark and
drill two holes in the wall.
> Using the two screws and wall plugs supplied
(A), fasten the wall bracket to the wall.
> When you have mounted the receiver cable as
described above, hang the receiver on the wall
bracket and secure it with screw (B).
> Fasten the cable to the wall and run it to
BeoSystem 1.
C
C
D
D
B
A
A
E
Green
Yellow
Brown