Bang & Olufsen BeoSystem 1 - User Guide - Manual (Page 44)

44
You can connect different types of
audio and video equipment to
BeoSystem 1, such as a video tape
recorder, set-top box or Camcorder.
Audio equipment is connected
through the Master Link socket.
When connecting video equipment
to BeoSystem 1, remember to use the
AV socket on BeoSystem 1 first, if it is
vacant. Should you require further
information about connections, refer
to the Reference book.
Refer to the guides included with
your additional equipment to make
sure it is connected properly.
Remember to register all connected
equipment. For further information
refer to the chapter ‘Register and use
additional video equipment’ on page
32.
Audio Master
Using a BeoLink cable, connect the one multi-
pin plug to the socket marked MASTER LINK
on BeoSystem 1, and the other multi-pin plug
to the socket marked MASTER LINK on the
audio system.
AV 2 Expander
The optional AV 2 Expander accessory is a
SCART expander for connection of non-
Bang & Olufsen equipment, such as decoders,
game consoles, and cameras to the DECODER
socket on BeoSystem 1. Use a 21-pin cable to
connect one plug to the socket marked TV on
the Expander box, and connect the other
plug to the socket marked DECODER on
BeoSystem 1. Remote control operation of
equipment connected via the AV 2 Expander
is not possible.
Set-top box
Use the 21-pin AV cable to connect the set-top
box to BeoSystem 1. To enable remote control
of your set-top box with the Beo4 remote
control, you must also connect a low-power
IR transmitter.
Decoder
To connect an AV decoder (a baseband
decoder, such as Canal+), connect the cable
from the aerial to BeoSystem 1. Connect the
AV decoder to the 21-pin socket marked
DECODER on BeoSystem 1.
To connect an RF decoder, connect the
external aerial cable to the decoder input
socket and then forward the cable to
BeoSystem 1 aerial socket (marked VHF/UHF).
Connect the RF decoder to the 21-pin socket
marked DECODER on BeoSystem 1.
Video tape recorder
Use a 21-pin cable to connect a BeoCord
V 8000 video tape recorder to the V.TAPE
socket on BeoSystem 1. Connect the cable
from the aerial to the input socket on the
video tape recorder. Forward the aerial cable
to the aerial socket on BeoSystem 1.
DVD player
Use a 21-pin cable to connect a DVD player,
such as a Bang & Olufsen DVD 1, to
BeoSystem 1. Connect one end to the socket
marked AV on your DVD player and the other
to the socket marked AV on BeoSystem 1.
Connect the socket marked DIGITAL OUTPUT
on DVD 1 to the SPDIF 1 socket on BeoSystem
1. If the required cable is not enclosed, it is
available from your Bang & Olufsen retailer.
Game console, Camcorder, etc.
We recommend that you use the close-up
socket panel for equipment you connect on a
temporary basis, such as a game console or
Camcorder. The use of these sockets is
explained in the chapter ‘Close-up socket
panel’ on page 48.
Connect additional equipment