Bang & Olufsen BeoVision MX_8000 - User Guide - Manual (Page 14)

14
We recommend that you follow the
procedure below when you set up
your BeoVision MX 8000:
– Unpack BeoVision MX 8000 and
place it as illustrated and described
to the right;
– Consider the appropriate
surroundings for BeoVision
MX 8000. Guidelines are included
to the right;
– Connect the cables to BeoVision
MX 8000 as described on the
facing page.
If you have additional equipment to
connect, such as a video tape
recorder or decoder, then refer to the
following pages or refer to the
BeoVision MX 8000 CD-rom.
How to set up BeoVision MX 8000
Appropriate surroundings for
BeoVision MX 8000
– Always place your BeoVision MX 8000 on a
firm and level surface.
– Allow a space of at least 5 cm above and to
each side of BeoVision MX 8000 for
adequate ventilation.
– Do not place BeoVision MX 8000 in direct
sunlight, directly under spotlights or near a
dimmer, as this might impede the infrared
remote operation of BeoVision MX 8000.
– The BeoVision MX 8000 is designed for
indoor use, in dry, domestic environments
with a temperature range between 10–40º C
(50–105º F).
– Do not place any items on top of BeoVision
MX 8000.
– Do not attempt to open your BeoVision
MX 8000. Leave such operations to qualified
service personnel.
NOTE! Specially designed stands are available for
placement of your TV. Contact your
Bang & Olufsen retailer for further information.
The BeoVision MX 8000 can also be placed on the
floor, in an upright position or at a slight tilt
backwards.
If your BeoVision MX 8000 is equipped with a
motorised stand, make sure that there is adequate
space for BeoVision MX 8000 to turn from side to
side as shown, when you position your BeoVision.