Bang & Olufsen BeoVision MX_8000 - User Guide - Manual (Page 26)

26
Settings for TV position
If your BeoVision MX 8000 is
equipped with the optional motorised
stand, you can turn it via the Beo4
remote control. You can also store
positions for the television to turn to
when it is switched on and when it is
switched to standby. You can also
turn your BeoVision MX 8000
manually.
> Press TV to switch on the television.
> Press MENU to call up the TV SETUP menu and
press ▼ to highlight STAND POSITIONS.
> Press GO to call up the STAND POSITIONS
menu.
> To store a stand position for when the BeoVision
MX 8000 is switched on, press ss or tt to turn
BeoVision MX 8000 and place it according to
your viewing position.
To store a stand position for when the
BeoVision MX 8000 is switched off and in
standby…
> Press ▼ to move to TV STANDBY.
> Press ss or tt to turn BeoVision MX 8000 and
place it as you wish.
> Press GO to store your positions.
Set a position for BeoVision
MX 8000 to turn to
You can set a position for BeoVision MX 8000
to turn to when you switch it on and off. You
can adjust the angle of BeoVision MX 8000
both manually and via the Beo4 remote
control.
PROGRAM GROUPS
TUNING
TIMER RECORDING
PLAY TIMER
OPTIONS
STAND POSITIONS
TV ON
TV STANDBY
TV SETUP
back select GO
left right
store
GO
TV ON
TV STANDBY
STAND POSTIONS
.
..
. . . . . . . . . . ..
..
Note! Refer to page 19 for information about first
time installation of the motorised stand.