Bang & Olufsen BeoVision MX_8000 - User Guide - Manual (Page 17)

17
BeoVision MX 8000 has a small
close-up operation and socket panel
on the front, just below the
television screen.
Here you can switch the system on
or off completely. If you switch the
system off, the indicator light on the
front of BeoVision MX 8000 will also
be switched off.
You can connect headphones or a
Camcorder via the close-up socket
panel on BeoVision MX 8000.
Close-up operation and socket panel
Switch the mains on or off
If you wish to switch off the mains completely
to your BeoVision MX 8000, you can do it by
pressing the mains switch on the close-up
operation and socket panel on the right-hand
side of BeoVision MX 8000, just below the
screen. When switched off like this, the red
standby light on the front disappears, and the
BeoVision MX 8000 can not be operated.
Connect headphones or Camcorder
Connect headphones to BeoVision MX 8000
via the socket marked PHONES on the right
side of the close-up operation and socket
panel. Connect a Camcorder to BeoVision
MX 8000 via the L, R and VIDEO sockets.
To connect headphones…
Connect headphones to BeoVision MX 8000 via
the PHONES socket on the close-up operation and
socket panel. Sound from the speakers is muted
when headphones are connected and activated
again when the headphones are disconnected.
To connect a Camcorder…
Connect your Camcorder to BeoVision MX 8000
via the sockets marked L, R, and VIDEO on the
close-up socket panel. L and R refers to the audio
signal, left and right speaker channel respectively,
whereas VIDEO is for the video signal.
R L VIDEO
Phones
Mains
switch
To watch your Camcorder recordings…
> Connect your camera.
> Press TV to switch on the television.
> Start playback on your Camcorder. Pictures
automatically appear on the screen.
> Operate your recordings via your Camcorder.
To select the Camcorder via the Beo4 remote
control…
> Press LIST repeatedly until CAMCORD* is shown
in the Beo4 display.
> Press GO to select the Camcorder.
To record your Camcorder recordings…
> If a BeoCord V 8000 is connected: Connect your
Camcorder and start playback as described
earlier.
> Press the RECORD button on Beo4 twice to
start recording.
Choosing another source or switching off
BeoVision MX 8000 during recording from a
Camcorder will disrupt recording. It is not possible
to view programs during recording.
*NOTE! In order to display CAMCORD on Beo4,
you must first add it to the Beo4 list of functions.
Refer to Beo4’s own Guide for further information.