Bang & Olufsen BeoPlayer - User Guide - Manual (Page 39)

39
All information concerning TV tuning only applies if BeoPort is
part of your setup and you have a compatible TV tuner card.
Before you start auto tuning TV channels for your TV tuner
card, make sure that the correct broadcast system is displayed
under ‘Video System’, that you have indicated whether your
connection is via cable or antenna, and that the correct
country is displayed.
> Click ‘AutoTune’ to start auto tuning TV channels.
During the tuning sequence, the located channels are shown
in the display. At any time you can stop the tuning and the
channels already found will be stored.
On the TV tuner cards, the TV channels you tune in are
registered as channel numbers and frequencies. Note that not
all TV tuner cards observe standard channel numbers for TV
channels.
Manual tuning
When you want to tune in a channel manually, if e.g. it was
not found during auto tuning, go to the ‘Manual’ section of
the ‘Tune’ menu.
> Scroll through the frequencies to find the frequency you
want to add.
> Click ‘Add’.
Moving or deleting tuned TV channels …
Once you have tuned and stored your TV channels, you can
rearrange the order in which they appear in the channel list.
You can, for example, rearrange them in accordance with the
order of TV channels on your television.
You can also delete channels from the channel list. Both actions
are performed in the ‘Configuration’ menu.
Basic settings