Racktuner btr2000, Metronome – Behringer Racktuner BTR2000 User Manual
Page 13
13
RACKTUNER BTR2000
DEUTSCH
5. METRONOME
The integrated metronome in the BTR2000 has a range of 30 beats per minute (BPM) to 240 BPM.
There are essentially 2 ways to use the metronome:
s
You can pre-set a tempo (e.g. 60 BPM).
s
The BTR2000 can pick up a tempo set by you.
To use the metronome, the BTR2000 must be in metronome mode:
1.
Press and hold the SOUND/METRONOME button for 2 seconds.
2.
The metronome function is selected when the METR light above the button is lit.
3.
Briefly press INPUT SELECT; the click and the optical display of the metronome start up.
+
The metronome values set most recently (BPM, type of graphic display, click volume,
MUTE) are stored when the BTR2000 is turned off.
5.1 Setting the BPM rate
1.
Set the BTR2000 to metronome mode (press and hold the SOUND/METRONOME button for 2
seconds).
2.
The selected BPM rate appears in the display.
3.
You can adjust the BPM rate using the wheel.
4.
Briefly press the INPUT SELECT button. The metronome starts up.
5.
The selected tempo appears in the display and is indicated optically and acoustically.
5.2 Using the TAP function
1.
Set the BTR2000 to metronome mode (press and hold the SOUND/METRONOME button for 2
seconds).
2.
Press the TAP button at least 4 times in succession in the desired tempo. During your entry, the
letters tap appear in the display.
3.
The BTR2000 metronome takes this tempo and displays it in BPM.
+
If the TAP button is pressed fewer than four times, the metronome returns to the last set
value after 2 seconds.
4.
If necessary, the tempo can be readjusted after setting using the wheel.
5.
Briefly press the INPUT SELECT button. The metronome starts up.
6.
The detected tempo is indicated visually and acoustically.
5.3 Acoustic and visual BPM indicator
Visual display
The BTR2000 has two ways of indicating the selected tempo on the LED bar:
s
A flashing light indicates the tempo.
s
A light moves constantly from one side to the other with the beat. This simulates the needle of
a standard mechanical metronome.
You can toggle between these two display types as follows:
1.
Set the BTR2000 to metronome mode (press and hold the SOUND/METRONOME button for 2
seconds).
2.
Start the metronome by pressing the INPUT SELECT button.
3.
Briefly press the MODE/FINE button to toggle between the two display types.
5. METRONOME