Behringer Racktuner BTR2000 - Manual (Page 7)

7
RACKTUNER BTR2000
DEUTSCH
2.2 Rear
Fig. 2.3: Serial number and sockets on the rear of the BTR2000
SERIAL NUMBER
MUTE
You can connect a single footswitch (such as the BEHRINGER DUAL A/B SWITCH AB200) to the
1/4" TS MUTE connector (chapter 6)
SELECT
You can connect a double footswitch (such as the BEHRINGER FS112) to the 1/4" stereo
SELECT connector (chapter 6)
SOUND
The SOUND connector can output the sounds generated by the unit (reference tone, metronome
click).
MAIN
Depending on the cable connections on the BTR2000 the MAIN connector can either output the
sounds generated by the unit and the instrument signal or the instrument signal alone (chapter 3).
INPUT 1 and INPUT 2
You can connect one or two instruments to the unit via the INPUT 1 and INPUT 2 connectors.
The built-in microphone is available only when INPUT 2 is selected (chapter 3).
3. INPUT CHANNEL SELECTION
Signal distribution to the outputs
The BTR2000 has 2 inputs and 2 outputs. Depending on the input selection and on what is connected
to the outputs, the sounds generated by the unit (metronome click and reference tones) can be output
from the SOUND connector or from the MAIN output connector together with the instrument signal.
You can decide whether to use two different amplifiers for the instrument sound and the BTR2000
sounds or just one.
Possible connection configurations:
Tr‡ˆƒГs‚ Г!Г6€ƒ† Tr‡ˆƒГs‚ Г Г6€ƒ
Listen to instrument and BTR2000 tones
utilizing
qvssr r‡Ãh€ƒ†
Listen to instrument and BTR2000 tones
utilizing
‡urÆh€rГh€ƒ
†ГГ Select ÃDIQVU Г‚
†ГГ Select DIQVU!à (to use the integrated
microphone, push MUTE as well)
Select DIQVU!Ã
(to use the integrated microphone, push MUTE
as well)
†Ã Connect instrument amp to H6DI ;
† Connect your amp to TPVI9 to hear
metronome click signal or reference tones
†Ãà Connect your amp to H6DI ;
†ÃÃI‚‡uvtà whatsoever may be connected
to TPVI9ÄÃ
Table 3.1: Setups for working with one or two amplifiers
3. INPUT CHANNEL SELECTION