Behringer Racktuner BTR2000 - Manual (Page 16)

16
RACKTUNER BTR2000
8. INSTALLATION
8.1 Rack installation
The BTR2000 requires one height unit (1 HU) for installation in a 19" rack. Be certain to leave an
additional 10 cm free in the back for the connectors. For installation in a rack, M6 machine screws and
nuts should be used.
Ensure a sufficient air supply and to not place your BTR2000 on an end, for example, to prevent the
unit from overheating.
8.2 Audio inputs and outputs
All audio inputs and outputs on the BEHRINGER BTR2000 are laid out as mono TS connectors.
Fig. 8.1: 1/4" TS connector
8.3 Footswitch wiring
If a double footswitch is plugged into the SELECT connector on the back of the BTR2000, the MUTE
function is transmitted on the ring and SELECT is transmitted on the tip.
Fig. 8.2: 1/4" TRS connector plug of a double footswitch
+
Always make sure that only technically qualified people install and operate your
RACKTUNER. During and after the installation, all those handling the equipment need to be
sufficiently grounded in order to avoid the potentially damaging electrostatic discharge or
similar damage that could have a permanent adverse effect on your equipment.
8. INSTALLATION