Behringer Racktuner BTR2000 - Manual (Page 14)

14
RACKTUNER BTR2000
Acoustic indicator
The selected tempo is also output at the SOUND or MAIN connector.
+
If your instrument is plugged into INPUT 1, the metronome click is output only through the
SOUND connector. If it is plugged into INPUT 2, and the SOUND output is not in use, the
metronome click is output together with the instrument signal from the MAIN connector.
You can change the volume of the click at any time and thus control the volume ratio between
instrument and click if you are listening to both using one amp.
1.
Briefly press the SOUND/METRONOME button. The SOUND LED above the button lights up.
2. With the wheel you can adjust the volume of the click with 12 volume levels.
+
Even at the lowest volume level (1), the metronome click is still audible. The click can be
shut off with the MUTE button.
3. If the volume is not changed for some time or if the SOUND/METRONOME button is pressed
again, the SOUND light goes out.
The metronome can naturally be muted without affecting the visual display.
1.
Press the MUTE/LIGHT button.
2. The metronome click is muted and no longer output through the MAIN connector.
6. USING A FOOTSWITCH
Single footswitches can be plugged into the MUTE and SELECT connectors (not included).
+
Use only non-latching footswitches! The BEHRINGER DUAL A/B SWITCH AB200 is ideally
suited.
The following functions are available with the footswitch:
TUNER METRONOME
MUTE
To mute
MAIN output
To mute
MAIN output
SELECT
Toggle between INPUT1
and INPUT2/MIC inputs
Activate/deactivate
metronome
0RGH
6ZLWFK
Table 6.1: Options overview
If you have a double footswitch such as the BEHRINGER FS112, it must be connected to the SELECT
connector! Both functions (MUTE and SELECT) are then transmitted over a stereo connection and
can be controlled using the two buttons.
6. USING A FOOTSWITCH